NANO CARBON 999
This base material is the hardest and most durable in its kind, which helps the board runs vary fast and get less damage going over the metal rails and box edges. With the precise and through stone grinding finish applied, the board performs the best including on the Spring worst snow condition.
A very high-density Sintered base material with stone grinding finish that makes the board runs very fast. It also has a high anti-friction performance and durability which helps to protect the board from getting damaged.
Having high durability and speed characteristics, you can enjoy the board without much of Maintenance needs.
The boards are factory tuned with correct amount of grinding/tuning. This finish provides the fast running ability during the Spring sluggish snow season.
A Carbon Fiber (30mm wide) is placed ＞＜ pattern on the core bottom, producing a ideal combination of the response and torsional flex characteristics.
20mm width Basalt Fiber is laminated ＞＜ pattern on the bottom of the core, which produces slightly softer flex and response than 30mm Carbon Fiber.
Basalt is extracted from the volcano lava and the Basalt Fiber is tough and has a high response ability for making high Ollie.
This woven fabric laminated on the core offers soft and relaxed torsion flex. It is also responsible for the quick vertical flex as well as adding the strength and durability to the board.
30mm width carbon stringer is laminated on the bottom of the core to keep the flexibility and durability to the board.
Ideal sidewall Technology
All Allian boards are constructed with the sidewall which is strong and durable against the impact and damage. It also helps to provides a comfortable board flex.
|SIDECUTS and SHAPES
Nose and tail section have identical shape allowing the switch riding easy for park riding.
The nose is longer than the tail of the board. The nose width is often wider than the tail allowing more nose float during the power riding.
A twin tip board with the setback stance position. The bindings are mounted 1-3cm towards the tail, enhancing a better free riding while the switch is still fun.
It gives the board a strong edge control and running stability together with the pop for higher ollie
Having approximately 4mm camber for the best performance when jibbing and street riding with sufficient edge control at high speed riding.
DIRECTIONAL TWIN CAMBER
Twin camber board with the set-back insets For directional freeriding
A small amount of reverse camber (rocker) at the board center with strong cambers under the bindings produces the best riding combination.
Having relatively short and medium deep camber under your bindi ngs together with flat aeras on each contact points for adding more stability during the nose and tail press. (ground tricks)